Panic Buying Is Not Allowed

Prices Can be change after placing order because of big pkr currency devaluation. 

 0312-400-2221 WhatsApp Logo PNG Images Free DOWNLOAD | By Freepnglogos.com

10S 36V 30A Li-ion Protection Board Li-ion Cell 18650 Battery Protection BMS

NLY4
Price=1,900
B383
In stock
+
Add to wish list

Has balance function which would ensure each cell being fully charged at same time.Overcharge protection, over-discharge protection and short circuit protection.
With temperature control protection function. Fine workmanship and good performance. Safe and reliable. Easy to use. Long service life. Suitable for 10 series cell Li-ion batteries, can be used for 3.7V ternary batteries, manganese acid batteries and cobalt acid batteries. Suitable for electric car, electric assistant car, skateboard car, inverter, etc.10S 36V 30A Li ion Cell 18650 Battery Protection BMS PCB Board With Balance  Function|Tool Parts| - AliExpress

 

Specificaitons:

  • Applicable Voltage: 36V
  • Applicable : less than 1000w
  • Max. Working Current: 30A
  • Continuous Maximum Current: 20A
  • Over-discharge Protection Voltage: 2.6v
  • Overcharge Protection Voltage: 4.25v
  • Charg Current: max. 10A
  • Balance Voltage: 4.2v
  • High Temperature Discharge: 75 ℃
  • Low Temperature Charge: - 7 ℃
  • colour: silver
  • Material: metal

BMS Protection Board Wiring Steps:

  1. 1. Firstly connect the batteries in series
  2. 2. Ensure that the voltage of each string is the same (the difference between the highest voltage and the lowest voltage is preferably within 0.1V), and the voltage range is between 3.2-4.0V.
  3. 3. Firstly connect the distributed cable, connect according to the diagram, and insert the cable port into the board port after checking it is correct (first connect the battery, then insert the board, the step cannot be reversed).
  4. 4. Check whether the total positive voltage of the C-port and P-port to the battery is equal to the total voltage of the battery. If they are equal, the board is working normally.
  5. 5. Solder the battery negative B- to the port marked B- on the board.
  6. 6. Both the battery output negative electrode and the charging negative electrode of the same port board are connected to the port marked C- on the board (the P- port is just floating).
  7. 7. Separate port (different port) board, the battery output negative pole is welded P-, and the charging negative pole is welded into the port marked C- on the board.

Package Contents:

  • 1 x Protection Board
  • 1 x Cable

10S 36V 30A Li-ion Cell 18650 Battery Protection BMS PCB Board With Balance Function, Battery Protection Board, Lithium Battery Protection Board

No posts found

Write a review