This is a great little RFID Reader Module from Innovations, simillar to the ID models (the difference being no silicone protection on the back). If you need an inexpensive way to get started with RFID, this is a great little module. Just power the module, and it will read any RFID card within range.
It will output the cards ID in a serial string, which can easily be read by any micro-controller. The spacing on the pins is 2.54 mm, which means the module will directly fit on a breadboard.
Here is a great little tutorial we did, to help you get started with this module!
Note:?This Module will not work with the Atmega32u2 Developement Board.
Pin No. | Name | Function |
---|---|---|
1 | VCC | 5V |
2 | GND | Ground |
3 | BEEP | BEEP and LED |
4 | ANT | No Use |
5 | ANT | No Use |
6 | SEL | HIGH selects RS232, LOW selects WEIGAND |
7 | TX | UART TX, When RS232 is Selected |
8 | D1 | WIEGAND Data 1 |
9 | D0 | WIEGAND Data 0 |
1xEM-18 EM18 RFID Reader Module
No posts found